PrepAway - Latest Free Exam Questions & Answers

Tag: network administrator

Which two options provide adequate routing table information for traffic that passes between the two routers a

Refer to the exhibit.The network administrator requires easy configuration options and minimal routing protocol traffic.Which two options provide adequate routing table information for traffic that passes between the two routers and satisfy the requests of the network administrator?(choose two)

Complete the network diagram by dragging the correct device name…

Refer to the exhibit. Complete the network diagram by dragging the correct device name or description to the correct location. Not all the names or descriptions will be used.

Give this output for SwitchC, what should the network administrator's next action be?

Refer to the exhibit. Give this output for SwitchC, what should the network administrator’s next action be?

What does this signify, and how should the network administrator respond?

Refer to the exhibit. A router boots to the prompt shown in the exhibit. What does this signify, and how should the network administrator respond?

What is the caust of the problem?

Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?

Which topology will provide some redundancy to increase reliablity for all sites but will cost less than a ful

A network administrator is designing a new corporate internetwork. The corporation is concerned about downtime due to link failure and also about link costs. Which topology will provide some redundancy to increase reliablity for all sites but will cost less than a fully redundant topology?

What action could the network administrator take to prevent access by multiple laptops through a single switch

Refer to the exhibit. Some 2950 series switches are connected to the conference area of the corporate headquarters network. The switches provide two to three jacks per conference room to host laptop connections for employees who visit the headquarters office. When large groups of employees come from other locations, the network administrator often finds that hubs have been connected to wall jacks in the conference area although the ports on the access layer switches were not intended to support multiple workstations.
What action could the network administrator take to prevent access by multiple laptops through a single switch port and still leave the switch functional for its intended use?

Based on the partial outputs in the exhibit, what could be the problem?

Refer to the exhibit. From RouterA, a network administrator is able to ping the serial interface of RouterB but unable to ping any of the subnets attached to RouterB. Based on the partial outputs in the exhibit, what could be the problem?


Page 1 of 41234