4 Comments on “Which command would a troubleshooter use to verify table connection info (peak, concurrent) and verify informa”

1. Alon says:

   January 11, 2016 at 10:05 pm

   seem to me that the correct answer is “C.fw ctl pstat”
   because there is no command like “Show info all” even in clish,
   and “fw tab –t connections –s” have no info about cluster sync’
   and “fw ctl multik stat” is not correct command

   
   
   
   1

   
   
   
   0
2. Alon says:

   January 11, 2016 at 10:07 pm

   correction – “fw ctl multik stat” is correct command but for CoreXL… 🙂

   
   
   
   0

   
   
   
   2
3. Crono says:

   January 20, 2016 at 6:35 pm

   I would have to disagree and say fw ctl pstat command. Multik shows peak and concurrent conenctions, however does not provide info State Synchronization like pstat does.

   Tricky question here.

   
   
   
   1

   
   
   
   0
4. myki says:

   May 6, 2017 at 5:43 am

   I agree with Alon.
   So correct answer is C

   
   
   
   1

   
   
   
   0