Refer to the exhibits Exhibit 1 This data center topology is being set up to use SPBM. VMs
in the same subnet should be able to communicate at Layer 2 and be isolated at Layer 2
from other subnets. VS110010 was created for VLAN 10 as shown in Exhibit 2. The
administrator is configuring a service instance for the VLAN 10 traffic on Switch 1 interface
Ten1/0/1. What is the correct encapsulation mode?
A.
s-vid101
B.
ta99ed
C.
default
D.
s-vid10
answer A or C
anyone can confirm
0
0
I think A
0
0
C is the correct answer.
As per student lab guide:
Configure the interface to Host1 (Ten1/0/7) with a service instance which
matches untagged traffic (like a VLAN access port) and bind (xconnect) it to
the VSI 1XX1
[p13-core1] interface ten1/0/7
[p13-core1-Ten-GigabitEthernet1/0/7] service-instance 1
[p13-core1-Ten-GigabitEthernet1/0/7-srv1] encapsulation default
0
0
Sorry, my apology. The above was wrongly quoted as customer VLAN traffic is tagged.
Answer should be D, SVID10 as per configuration guide below:
[p13-core1-Ten-GigabitEthernet1/0/2] service-instance 1
[p13-core1-Ten-GigabitEthernet1/0/2-srv1] encapsulation s-vid 1XX1
[p13-core1-Ten-GigabitEthernet1/0/2-srv1] xconnect vsi 1XX1 access vlan
0
0