What network information is required to set up any Cisco switches attached to a clustered Data
ONTAP system? (Choose two.)

A.
All management ports configured for e0d or the service port (wrench icon) are required.

B.
VLAN tags for each interface are required.

C.
Host names and IP addresses for each of the controllers and configured switches are required.

D.
The appropriate number and type of cables and cable connectors for your switches are
required.

Explanation:
C: You need the following network information for all switch configurations:
*Two or more IP subnet addresses for cluster network and management network traffic
* Host names and IP addresses for each of the controllers and all applicable switches
* Management network port assignments for your controller
D: To configure your cluster, you need the appropriate number and type of cables and cable
connectors
for your switches. Depending on the type of switch you are initially configuring, you need to
connect
to the switch console port with the included console cable. Clustered Switch Setup Guide for Cisco Switches, page 8
https://library.netapp.com/ecm/ecm_download_file/ECMP1115327