In a Fibre Channel configuration, the host’s HBA is referred to as the _____________ and the storage app
In a Fibre Channel configuration, the host’s HBA is referred to as the _____________ and the storage appliance’s HBA is referred to as the _________.
At Network Appliance, the presence of iSCSI or FCP SAN and NAS storage on the same storage appliance is referr
At Network Appliance, the presence of iSCSI or FCP SAN and NAS storage on the same storage appliance is referred to as _________.
Which of the following commands would you use to troubleshoot the failure?
You receive the following error message:
ISCSI: iswta Authentication failed for initiator xyz; Which of the following commands would you use to troubleshoot the failure?
What is the purpose of the iSCSI target adapter iswtb?
In an iSCSI target configuration, there are two ISWT adapters. The purpose of adapter iswta is for local traffic. What is the purpose of the iSCSI target adapter iswtb?
Given the output below, the reason is because all of the LUNs are using the same LUN ID of 0…
You are having problems accessing three recently created LUNs. Given the output below, the reason is because all of the LUNs are using the same LUN ID of 0.
lun show -m
LUN pathMapped to LUN ID
—-
/vol/vol1/lun0 solaris-igroup0 0
/vol/vol1/lun1 solaris-igroup1 0
/vol/vol1/qtree1/lun2 solaris-igroup2 0
/vol/vol1/qtree1/lun3 solaris-igroup3 0
what can you determine from the LUNs that are mapped to "via RPC"?
Network Appliance supports certain fiber switch models from the following three vendors: Brocade Cisco McData
Network Appliance supports certain fiber switch models from the following three vendors:
Brocade
Cisco
McData
Given that there is no real flow control in FCP SAN, attention should be given to monitoring queue depths
Given that there is no real flow control in FCP SAN, attention should be given to monitoring queue depths.
What is the outcome of the following command ?
What is the outcome of the following command ? lun create -b /vol/vol2/.snapshot/testsnap/lun0 /vol/vol2/lun0.clone
Before running lun setup on the storage appliance, you must pre-create the igroup to which the initiator will
Before running lun setup on the storage appliance, you must pre-create the igroup to which the initiator will be attached.