Your network contains a server named Server1 that has the Network Policy and Access
Services server role installed.
All of the network access servers forward connection requests to Server1.
You create a new network policy on Server1.
You need to ensure that the new policy applies only to connection requests from the
192.168.0.0/24 subnet.
What should you do?
A.
Set the Client IP4 Address condition to 192.168.0.0/24.
B.
Set the Client IP4 Address condition to 192.168.0.
C.
Set the Called Station ID constraint to 192.168.0.0/24.
D.
Set the Called Station ID constraint to 192.168.0.
Explanation:
RADIUS client properties
Following are the RADIUS client conditions that you can configure in network policy.
• Calling Station ID: Specifies the network access server telephone number that was
dialed by the dial-up access client.
• Client Friendly Name: Specifies the name of the RADIUS client that forwarded the
connection request to the NPS server.
• Client IPv4 Address: Specifies the Internet Protocol (IP) version 4 address of the
RADIUS client that forwarded the connection request to the NPS server.
• Client IPv6 Address: Specifies the Internet Protocol (IP) version 6 address of the
RADIUS client that forwarded the connection request to the NPS server.
• Client Vendor: Specifies the name of the vendor or manufacturer of the RADIUS
client that sends connection requests to the NPS server.
• MS RAS Vendor: Specifies the vendor identification number of the network access
server that is requesting authentication.
Set the Client IP4 Address condition to 192.168.0.*
0
0
“http://networkshenanigans.files.wordpress.com/2014/05/wildcard_ipv4.jpg”
this guy was setting a NPS connection request policy condition
only he used “Client IP4 Address” of “*.*.*.*”
question maybe has a typo
0
0
To specify a range of all IP addresses that begin with 192.168.1, the syntax is: 192\.168\.0\..+
0
0
B
0
0
seen a similar q in this format
Your network contains a server named Server1 that has the Network Policy and Access Services server role installed. All of the network access servers’ forward connection requests to Server1.
You create a new network policy on Server1. You need to ensure that the new policy applies only to connection requests from Microsoft RAS servers that are located on the 192.168.0.0/24 subnet. Which two configurations should you performing? (Each correct answer presents part of the solution. Choose two.)
a Set the MS-RAS Vendor ID condition to $teelHead.
b Set the Called Station ID constraint to 192.168.0.
c Set the Client IP4 Address condition to 192.168.0.0/24.
d Set the MS-RAS Vendor ID condition to ^311$.
e Set the Called Station ID constraint to 192.168.0.0/24.
f Set the Client IP4 Address condition to 192.168.0.
Correct Answer: DF
0
0
@olie
Can you explain to me why D ?
0
0