One Comment on “What is corresponding device name on a Linux system?”

1. GG says:

   May 7, 2014 at 12:56 pm

   The correct answer depends on two factors:

   – The version of GRUB
   – If the partition is Primary, or Logical on an Extended partition

   In GRUB2 (prevalent since 2009) the partition numbers are counted from one, not from zero as was the case in GRUB version 1 (also known as GRUB Legacy and V0.97).

   Partition numbers for logical partitions on extended partitions are counted from ‘5’, regardless of the actual number of primary partitions on your hard disk. The MBR is limited to four primary partitions, and a single primary partition can hold an extended partition which can then be divided into logical partitions.

   Therefore:

   GRUB1 GRUB2
   HD0,0 /dev/hda1 Primary HD0,1 /dev/hda1
   HD0,1 /dev/hda2 Primary HD0,2 /dev/hda2
   HD0,2 /dev/hda3 Primary HD0,3 /dev/hda3
   HD0,3 /dev/hda4 Primary HD0,4 /dev/hda4

   HD0,4 /dev/hda5 Logical HD0,5 /dev/hda5
   HD0,5 /dev/hda6 Logical HD0,6 /dev/hda6
   …

   HD1,0 /dev/hdb1 Primary HD1,1 /dev/hdb1
   HD1,1 /dev/hdb2 Primary HD1,2 /dev/hdb2
   HD1,2 /dev/hdb3 Primary HD1,3 /dev/hdb3
   HD1,3 /dev/hdb4 Primary HD1,4 /dev/hdb4

   HD1,4 /dev/hdb5 Logical HD1,5 /dev/hdb5
   HD1,5 /dev/hdb6 Logical HD1,6 /dev/hdb6

   Answer C is correct for a GRUB2 Primary partition

   Answer D is correct for a GRUB1 Extended partition

   Much of the LPI certification seems to be stuck in legacy apps such as GRUB1 and XFree86.

   Comments?

   
   
   
   0

   
   
   
   0