You are monitoring the control plane traffic using a network analyzer on an Ethernet
network segment with all routers configured with IS-IS routing. Which two statements are
true? (Choose two.)

Click the Exhibit button. In the exhibit, Customer A uses private RFC1918 addresses within
its network. The customer wants to have all Internet access for its organization transit
through the main office for security and NAT purposes. Each of the PE routers in your
network contains Internet routes in the main instance routing table and is capable of
provisioning both a VRF and a non-VRF interface to its attached CE router. Which router
should be configured to accomplish the administrative goal of the customer?

Click the Exhibit button. Customer A is complaining that routes advertised from the CE2
router are not being received on the CE1 router. The physical topology of the network is
CE1-PE1-PE2-CE2. The CE1-PE1 subnet is 172.16.1.0/24. The CE2-PE2 subnet is
172.16.2.0/24. PE1’s loopback is 192.168.3.1 and PE2’s loopback is 192.168.4.1.Referring
to the output in the exhibit, what is the problem?

Click the Exhibit button. In the exhibit, all routers within each AS are configured for Anycast
RP. All intra-AS routers are configured within the same MSDP mesh group. Inter-AS
multicast has been enabled using MSDP without MSDP mesh groups. Which statement is
true?

Click the Exhibit button. On your MX Series router, traffic using the less-critical scheduler is
out of profile. All other data is currently in profile. Referring to the exhibit, which statement is
correct?

Click the Exhibit button. Traffic is flowing through the policer as shown in the exhibit. The
traffic has a throughput rate of 3 Mbps, and the burst size counter is at 1.5 MB. How is
traffic affected?

Which two configuration parameters are required to configure an LDP-signaled VPLS
service? (Choose two.)

Click the Exhibit button. As shown in the exhibit, you have an LSP established from R1 to
R4. Your network experiences a link failure between R2 and R3.Which statement is correct?

Click the Exhibit button. What is the significance of RIB groups, as shown in the exhibit?

Click the Exhibit button. After adding Customer C to your Layer 3 VPN, you must validate
that PE2 is receiving VPN routes for all customers attached to PE1, as shown in the exhibit.
Which operational command displays this information?