— Exhibit –

— Exhibit —
Click the Exhibit button.
On AS1, which two attributes are used to influence inbound traffic from the other ASs shown in the
exhibit? (Choose two.)

— Exhibit –

— Exhibit —
Click the Exhibit button.
Referring to the exhibit, R2 is sending a route to R1 with a community value.
Which statement is correct?

Which set of BGP attributes is preferred by the Junos OS?

— Exhibit –
— Exhibit —
Click the Exhibit button.
Referring to the exhibit and based on the output below from Sw-1 and Sw-2, which statement is
true?
Sw-1> show spanning-tree mstp configuration
MSTP information
Context identifier : 0
Region name : juniper
Revision : 1
Configuration digest : 0x9357ebb7a8d74dd5fef4f2bab50531aa
MSTI Member VLANs
0 0-9,11-19,21-4094
1 10
2 20
Sw-2# run show spanning-tree mstp configuration
MSTP information
Context identifier : 0
Region name : juniper
Revision : 1
Configuration digest : 0x387b5f2ea2394b14e091f0921ee7b9a8
MSTI Member VLANs
0 0-9,11-14,16-19,21-4094
1 10,15
2 20

— Exhibit –

— Exhibit —
Click the Exhibit button.
R4 receives BGP prefixes for AS 50 from both R2 and R3. You want to ensure that R4 chooses
R3 as the preferred path to reach 50.50.50/24.
Referring to the information shown in the exhibit, where would you apply a policy containing the
parameter local-preference 110 to accomplish this task?

You want to provide reachability to your data center by advertising its subnet throughout your
upstream peer AS. However, you do not want this prefix advertised any further.
Which BGP community value would be used to meet this requirement?

— Exhibit –

— Exhibit —
Click the Exhibit button.
Referring to the exhibit, you want router A to have an EBGP peering with router C. They are both
connected through router B, which does not have BGP running, and has static routes configured.
What must be configured in the EBGP peer groups on routers A and C to make this connection
possible?

— Exhibit –

— Exhibit —
Click the Exhibit button.
Referring to the exhibit, your AS is connected to ISP-A and ISP-B using BGP. R1 and R2 are
advertising your AS’s 172.25/16 prefix upstream to both ISPs, and both ISPs are providing a full
BGP route table. You want to influence traffic flow so that traffic towards your network enters
through R1.
Which action would meet the requirement?
Apply the following as an export policy towards ISP-B:

— Exhibit –

— Exhibit —
Click the Exhibit button.
R1 is connected to both R2 and R3 and you want to load-balance outbound traffic. You have
provided the configuration shown in the exhibit; however, after checking the links you notice that
the traffic is not load-balancing.
Which configuration must be added?

— Exhibit —
[edit policy-options]
user@router# show
policy-statement LB {
term 1 {
then {
load-balance per-packet;
}
}
— Exhibit —
Click the Exhibit button.
Two routers are joined by redundant BGP connections. You want to load-balance traffic across
these links, and have configured the policy shown in the exhibit on each device.
Which configuration, applied on each device, correctly applies the policy to accomplish this task?