What configuration changes can reduce the memory utilization in a FortiGate? (Choose two.)

Four FortiGate devices configured for OSPF connected to the same broadcast domain. The first unit is elected as the designated router. The second unit is elected
as the backup designated router. Under normal operation, how many OSPF full adjacencies are formed to each of the other two units?

An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the
connection using HTTP. The output of the debug flow is shown in the exhibit:
Based on the error displayed by the debug flow, which are valid reasosns for this problem? (Choose two.)

An administrator has configured a dial-up IPsec VPN with one phase 2, extended authentication (XAuth) and IKE mode configuration. The administrator has also
enabled the IKE real time debug.
diagnose debug application ike -1
diagnose debug enable
In which order is each step and phase displayed in the debug output each time a new dial-up user is connecting to the VPN?

Examine the output of the ‘get router info ospf interface’ commsnd shown in the exhibit; then answer the question below.
Which statements are true regarding the above output? (Chosse two.)

Examine the following routing table and BGP configuration; then answer the question below.
#get router info routing-table all
* 0.0.0.0/0 [10/0] via 10.200.1.254, port1
C 10.200.1.0/24 is directly connected, port1
S 192.168.0.0/16 [10/0] via 10.200.1.254, port1
# show router bgp
config router bgp
set as 65500
set router-id 10.200.1.1
set network-import-check enable
set ebgp-miltipath disable
config neighbor
edit “10.200.3.1”
set remote-as 65501
next
end
config network
edit1
The BGP connection is up, but the local peer is NOT advertising the prefix 192.168.1.0/24. Which configuration change will make the local peer advertise this
prefix?

Examine the partial output from the IKE real time debug shown in the exhibit; then answer the question below.

Why didn’t the tunnel come up?

Examine the output of the ‘diagnose ips anomaly list’ command shown in the exhibit; then answer the question below.
Which IP addresses are included in the output of this command?

An administrator has enabled HA session synchronization in a HA cluster with two members. Which flag is added to a primary unit’s session to indicate that it has
been synchronized to the secondary unit?

Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?