Which statement is correct in this scenario?
You want to manage a FortiGate with the FortiCloud service. The FortiGate shows up in your list of devices on the FortiCloud Web site, but all management functions are either missing or grayed out. Which statement is correct in this scenario? A. The management tunnel mode on the managed FortiGate must be changed to normal. […]
Referring to the exhibit, what are two actions that will fulfill the requirements?
Refer to the exhibit. The exhibit shows a full-mesh topology between FortiGate and FortiSwitch devices. To deploy this configuration, two requirements must be met: • 20 Gbps full duplex connectivity is available between each FortiGate and the FortiSwitch devices • The FortiGate HA must be in AP mode Referring to the exhibit, what are two […]
Which statement is true regarding the session in the exhibit?
Examine the output of the ‘diagnose sys session list expectation’ command shown in the exhibit; than answer the question below. Which statement is true regarding the session in the exhibit? A. It was created by the FortiGate kernel to allow push updates from FotiGuard. B. It is for management traffic terminating at the FortiGate. C. […]
Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?
Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems? A. Diagnose debug application radius -1. B. Diagnose debug application fnbamd -1. C. Diagnose authd console –log enable. D. Diagnose radius console –log enable.
What should the administrator check to fix the problem?
A FortiGate is configured as an explicit web proxy. Clients using this web proxy are reposting DNS errors when accessing any website. The administrator executes the following debug commands and observes that the n-dns-timeout counter is increasing: What should the administrator check to fix the problem? A. The connectivity between the FortiGate unit and the […]
What is the meaning of the packets dropped counter at the end of the sniffer?
Examine the following partial output from a sniffer command; then answer the question below. What is the meaning of the packets dropped counter at the end of the sniffer? A. Number of packets that didn’t match the sniffer filter. B. Number of total packets dropped by the FortiGate. C. Number of packets that matched the […]
Which statements are true regarding the output in the exhibit?
Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below. Which statements are true regarding the output in the exhibit? (Choose two.) A. BGP state of the peer 10.125.0.60 is Established. B. BGP peer 10.200.3.1 has never been down since the BGP counters were cleared. […]
Which statements are true regarding the above output?
Examine the output of the ‘get router info ospf interface’ command shown in the exhibit; then answer the question below. Which statements are true regarding the above output? (Choose two.) A. The port4 interface is connected to the OSPF backbone area. B. The local FortiGate has been elected as the OSPF backup designated router. C. […]
Based on the above outputs, which is the FortiGuard web filter category for the web site www.fgt99.com?
Examine the partial output from two web filter debug commands; then answer the question below: Based on the above outputs, which is the FortiGuard web filter category for the web site www.fgt99.com? A. Finance and banking B. General organization. C. Business. D. Information technology.
What information is included in the output of the sniffer?
An administrator is running the following sniffer in a FortiGate: diagnose sniffer packet any “host 10.0.2.10” 2 What information is included in the output of the sniffer? (Choose two.) A. Ethernet headers. B. IP payload. C. IP headers. D. Port names.