A system administrator has configured a system using the Initial Configuration wizard. After completing the
wizard, the administrator discovers that an incorrect IP address has been assigned to the Unity system.
How can the IP address be changed?

A.
The IP address cannot be changed once it has been configured

B.
Through the Service interface using the ifconfig command

C.
In the Unisphere Settings menu

D.
The IP address can only be changed using the UEMCLI

Explanation:
The svc_initial_config UEMCLI command sets up initial system configuration. It configures a management IP
address when the Connection Utility (CU) is not available on the network. If an address is set, this command
can also change the management IPv4 and IPv6 configuration mode. It attempts to configure the system with
the given friendly name and/or network parameters.
Note: The Unisphere CLI (UEMCLI) is a tool that provides us with the CLI access to perform the same actions
as one would on the Unisphere web interface.
https://www.emc.com/collateral/TechnicalDocument/docu69328.pdf (page 60)