In a distributed call processing network with locations-based CAC, calls are routed to and from intercluster trunks. Which trunk type is implemented in this network?
A.
intercluster trunk with gatekeeper control
B.
intercluster trunk without gatekeeper control
C.
SIP trunk
D.
h225 trunk
Passed 300-075 Exam, not too difficult. Questions here is valid but answers are wrong. i got 7 new questions one day before i went to take this test! share here with you:
QUESTION
Cisco Unified Communications Manager is configured with CAC for a maximum of 10 voice calls.
Which action routes the 11th call through the PSTN?
A. Configure an SIP trunk to the ISR.
B. Configure Cisco Unified Communications Manager AAR.
C. Configure Cisco Unified Communications Manager RSVP-enabled locations.
D. Configure Cisco Unified Communications Manager locations.
Answer: B
QUESTION
Which solution is needed to enable presence and extension mobility to branch office phones during a WAN failure?
A. SRST with MGCP fallback
B. SRST without MGCP fallback
C. Cisco Unified Communications Manager Express in SRST mode
D. SRST with VoIP dial peers to Cisco Unified Communications Manager Express
Answer: C
QUESTION
Which option configures the secondary dial tone option for SRST mode to let the users hear the dial tone for PSTN calls?
A. voice service voip
secondary dialtone 0
B. call-manager-fallback
secondary dialtone 0
C. dial-peer voice 1 pots
secondary dialtone 0
D. ccm-manager secondary dialtone 0
Answer: B
QUESTION
Which action is performed by the Media Gateway Control Protocol gateway with SRST configured, when it loses connectivity with the primary and backup Cisco Unified Communications Manager servers?
A. The gateway continues to make an attempt to connect to the backup Cisco Unified Communications Manager server.
B. The gateway falls back to the H.323 protocol for further call processing.
C. The gateway continues with the MGCP call processing without any interruption.
D. The gateway waits for the primary Cisco Unified Communications Manager server to come alive.
E. All MGCP call processing is interrupted until the Cisco Unified Communications Manager servers are online.
F. The MGCP calls are queued up until the Cisco Unified Communications Manager servers are online.
Answer: B
QUESTION
Which three commands are mandatory to implement SRST for five Cisco IP Phones? (Choose three.)
A. call-manager-fallback
B. max-ephones
C. keepalive
D. limit-dn
E. ip source-address
Answer: ABE
QUESTION
Which parameter should be set to prevent H.323 endpoints from registering to Cisco TelePresence Video Communication Server automatically?
A. On the VCS, navigate to Configuration, Protocols, H.323, and set Auto Discover to off.
B. On the VCS, navigate to Configuration, Protocols, H.323, and set Auto Registration to off.
C. On the VCS, navigate to Configuration, Registration, Allow List, and set Auto Registration to off.
D. On the VCS, navigate to Configuration, Registration, Configuration, and set Auto Registration to off.
Answer: A
QUESTION
Which two statements about configuring mobile and remote access on Cisco TelePresence Video Communication Server Expressway are true? (Choose two.)
A. The traversal server zone on Expressway-C must have a TLS verify subject name configured.
B. The traversal client zone and the traversal server zone Media encryption mode must be set to Force encrypted.
C. The traversal client zone and the traversal server zone Media encryption mode must be set to Auto.
D. The traversal client zone on Expressway-C Media encryption mode must be set to Auto.
E. The traversal client zone and the traversal server zone must be set to SIP TLS with TLS verify mode set to On.
Answer: BE
QUESTION
A voicemail product that supports only the G.711 codec is installed in headquarters. Which action allows branch Cisco IP phones to function with voicemail while using only the G.729 codec over the WAN link to headquarters?
A. Configure Cisco Unified Communications Manager regions.
B. Configure transcoding within Cisco Unified Communications Manager.
C. Configure transcoding resources in Cisco IOS and assign to the MRGL of Cisco IP phones.
D. Configure transcoder resources in the branch Cisco IP phones.
Answer: C
got them at someone’s post: http://www.pass1st.com/?s=300-075 , this guy share his exam study materials totally for free view, you also can go to check every day updation.
0
0
More new Cisco 300-075 Questions:
QUESTION
Which of the following are two functions that ensure that the telephony capabilities stay operational in the remote location Cisco Unified SRST router? (Choose two)
A. Automatically detecting a failure in the network.
B. Initiating a process to provide call-processing backup redundancy.
C. Notifying the administrator of an issue for manual intervention.
D. Proactively repairing issues in the voice network.
Answer: AB
QUESTION
Which three of the following are steps in configuring MGCP Fallback and Cisco Unified SRST? (Choose three)
A. Define the SRST reference for phones in the Device Pool configuration
B. Enable and configure the MGCP fallback and Cisco Unified SRST features on the IOS gateways.
C. Implement a simplified SRST dial plan on the remote-site-gateways to ensure connectivity for remote-site phones in SRST mode.
D. Enable SIP trunking between both remote and hub sites to provide mesh coverage.
E. Define the SRST reference in the configuration on the IP Phones.
F. Enable and configure the MGCP fallback on the IOS gateway but not Cisco Unified SRST since it is enabled automatically.
Answer: ABC
QUESTION
Which method can be used to address variable-length dial plans?
A. Overlap sending and receiving.
B. Add a prefix for all calls that are longer than 10-digits long
C. Use nested translation patterns to eliminate inter-digit timeout
D. Use the @macro on the route pattern
E. Use MGCP gateways, which support variable-length dial plans
Answer: A
Explanation:
If the dial plan contains overlapping patterns, Cisco Unified Communications Manager does not route the call until the interdigit timer expires (even if it is possible to dial a sequence of digits to choose a current match). Check this check box to interrupt interdigit timing when Cisco Unified Communications Manager must route a call immediately. By default, the Urgent Priority check box displays as checked. Unless your dial plan contains overlapping patterns or variable length patterns that contain!, Cisco recommends that you do not uncheck the check box.
QUESTION
Refer to the exhibit. Which trunks would be most suitable for Connection Y?
A. an H.225 trunk (gatekeeper-controlled)
B. intercluster trunk (gatekeeper-controlled)
C. a SIP trunk on the U.S. cluster and an intercluster trunk on the remote cluster
D. intercluster trunk (nongatekeeper-controlled)
E. No extra connections are required. As long as IP connectivity exists, you need only configure a route pattern for each site. The Cisco Unified Communications Manager will automatically forward the calls over the WAN if the destination directory number is not registered locally.
Answer: D
QUESTION
Which two features require or may require configuring a SIP trunk? (Choose two.)
A. SIP gateway
B. Call Control Discovery between a Cisco Unified Communications Manager and Cisco Unified Communications Manager Express
C. Cisco Device Mobility
D. Cisco Unified Mobility
E. registering a SIP phone
Answer: AB
Explanation:
All protocols require that either a signaling interface (trunk) or a gateway be created to accept and originate calls. Device mobility allows Cisco Unified Communications Manager to determine whether the phone is at its home location or at a roaming location. Cisco Unified Mobility gives users the ability to redirect incoming IP calls from Cisco Unified Communications Manager to different designated phones, such as cellular phones.
QUESTION
A Cisco 3825 needs to be added in Cisco Unified Communications Manager as an H.323 gateway. What should the gateway type be?
A. H.323 gateway
B. Cisco 3825
C. Cisco 3800 series router. The specific model will be selected after the Cisco 3800 is selected.
D. The gateway can be added either as an H.323 gateway or Cisco 3800 series router.
E. The gateway can be added either as an H.323 gateway or Cisco 3825 series router.
Answer: A
QUESTION
When an incoming PSTN call arrives at an MGCP gateway, how does the calling number get normalized to a global E.164 number with the + prefix in Cisco Unified Communications Manager?
A. Normalization is done using translation patterns.
B. Normalization is done using route patterns.
C. Normalization is done using the gateway incoming called party prefixes based on number type.
D. Normalization is done using the gateway incoming calling party prefixes based on number type.
E. Normalization is achieved by local route group that is assigned to the MGCP gateway.
Answer: D
Explanation:
Configuring calling party normalization alleviates issues with toll bypass where the call is routed to multiple locations over the IP WAN. In addition, it allows Cisco Unified Communications Manager to distinguish the origin of the call to globalize or localize the calling party number for the phone user.
QUESTION
When an incoming PSTN call arrives at an MGCP gateway, how does the called number get normalized to an internal directory number in Cisco Unified Communications Manager?
A. Normalization is done by configuring the significant digits for inbound calls on the MGCP gateway.
B. Normalization is done using route patterns.
C. Normalization is done using the gateway incoming called party prefixes based on number type.
D. Normalization is done using the gateway incoming calling party prefixes based on number type.
E. Normalization is achieved by local route group that is assigned to the MGCP gateway.
Answer: A
QUESTION
Which process can localize a global E.164 with + prefix calling numbers for inbound calls to an IP phone so that users see the calling number in a local format?
A. Calling number localization is done using translation patterns.
B. Calling number localization is done using route patterns.
C. Calling number localization is done by configuring a calling party transformation CSS at the phone.
D. Calling number localization is done by configuring a calling party transformation CSS at the gateway.
E. Calling number localization is done by configuring the phone directory number in a localized format.
Answer: C
Full Version: https://www.braindump2go.com/300-075.html
0
0