When configuring a routed port on a Cisco multilayer switch, which configuration task is needed to enable that
port to function as a routed port?
A.
Enable the switch to participate in routing updates from external devices with the router command inglobal
configuration mode
B.
Enter the no switchport command to disable Layer 2 functionality at the interface level
C.
Each port participating in routing of Layer 3 packets must have an IP routing protocol assigned on aperinterface level
D.
Routing enabled by default on a multilayer switch, so the port can become a Layer 3 routing interface by
assigning the appropriate IP address and subnet information
The port needs an IP address configured to function as routed port. “no switchport” is not the complete answer to this question. I propose D to be the correct answer.
0
0
D is wrong. Routing is not enabled by default. The first thing you have to do is enter the “no switchport” command, so B is the best answer.
0
0