Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs
to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.
· DSW1 primary device for VLAN 101 VLAN 102 and VLAN 105
· DSW2 primary device for VLAN 103 and VLAN 104
· A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on
backup device has also failed.

Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to
investigate and respond to the following question.

During routine maintenance, GigabitEthernet1/0/1 on DSW1 was shut down. All other interfaces were up. DSW2 became the active HSRP device for VLAN 101 as
desired. However, after GigabitEthemet1/0/1 on DSW1 was reactivated, DSW1 did not become the active router for VLAN 101 as desired. What needs to be done
to make the group for VLAN 101 function properly?

A.
Enable preempt in the VLAN 101 HSRP group on DSW1.

B.
Disable preempt in the VLAN 101 HSRP group on DSW2’s.

C.
In the VLAN 101 HSRP group on DSW1, decrease the priority value to avaluethatis less ` than
the priority value configured in the VLAN 101 HSRP group on DSW2.

D.
Decrease the decrement value in the track command for the VLAN 101 HSRP group on U DSWTs to a values less than the value in the track command for the
VLAN 101 HSRP group on DSW2.

Explanation: