Refer to the exhibit.

What is the result of the configuration?

A.
The EtherChannels would not form because the load-balancing method must match on the devices.

B.
The EtherChannels would form and function properly even though the load-balancing and EtherChannel modes do not match.

C.
The EtherChannels would form, but network loops would occur because the load-balancing
methods do not match.

D.
The EtherChannels would form and both devices would use the dst-ip load-balancing method because Switch1 is configured with EtherChannel mode active.

Explanation:
An etherchannel will form if one end is active and the other is passive. The table below sum-marizes the results for LACP channel establishment based on the
configuration of each side of a link:
LACP Channel Establishment
S1
S2
Established?
On
On
Yes
Active/Passive
Active
Yes
On/Active/Passive
Not Configured
No
On

Active
No
Passive/On
Passive
No
Load balancing can only be configured globally. As a result, all channels (manually configured, PagP, or LACP) use the same load-balancing. This is true for the
switch globally, although each switch involved in the etherchannel can have non matching parameters for load balancing.
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12- 2/54sg/configuration/guide/config/channel.html#wp1020804