4 Comments on “What is the bandwidth on the WAN interface of Router 1?”

1. ish says:

   February 28, 2016 at 4:33 am

   According to the information above, the “show running-configuration” and “show startup-configuration” have been disabled. To view IP configuration of the LAN network connected to Router1, you can use the show ip interface command . Below is a copy of the command output:

   orbitco-CCNA-pastquestions.com

   From the output you can see that the IP address of the FastEthernet0/0 interface of Router1 is 192.168.10.1 and the subnet mask is /28.

   If you follow the table, the increment is in 16s which is /28 or 240 mask.
   Network address: 192.168.10.0
   Broadcast address: 192.168.10.15 (15 = 0 + 16 -1)

   So, The broadcast address for this subnet is 192.168.10.15
   http://www.orbitco-ccna-pastquestions.com/ICND-1-Lab-

   
   
   
   0

   
   
   
   0
2. noir says:

   March 23, 2016 at 6:15 am

   Show interface for the bandwith

   
   
   
   0

   
   
   
   0
3. noir says:

   March 23, 2016 at 6:37 am

   R1#Show interfaces
   FastEthernet0/0 is administratively down, line protocol is down
   Hardware is MV96340 Ethernet, address is 0013.197b.1101 (bia 0013.197b.1101)
   MTU 1500 bytes, BW 100000 Kbit/sec

   
   
   
   0

   
   
   
   0
   1. noir says:

      March 23, 2016 at 6:37 am

      BW = bandwidth

      
      
      
      0

      
      
      
      0