Which set of commands will accomplish this task?
A network administrator needs to allow only one Telnet connection to a router. For anyone viewing the confguration and issuing the show run command, the password for Telnet access should be encrypted. Which set of commands will accomplish this task?
Which protocols were used during the test?
A network administrator issues the ping 192.168.2.5 command and successfully tests connectivity to a host that has been newly connected to the network. Which protocols were used during the test? (Choose two.)
Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy?
The network security policy requires that only one host be permitted to attach dynamically to each switch interface. If that policy is violated, the interface should shut down. Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy? (Choose two.)
What can the administrator do to ensure that only the MAC address of the server is allowed by…
A network administrator wants to ensure that only the server can connect to port Fa0/1 on a Catalyst switch. The server is plugged into the switch Fa0/1 port and the network administrator is about to bring the server online. What can the administrator do to ensure that only the MAC address of the server is allowed by switch port Fa0/1? (Choose two.)
Which destination addresses will be used by Host A to send data to Host C?
Which destination addresses will be used by Host A to send data to Host C? (Choose two.)
What are two reasons why the Certkillernetwork administrator would use CDP?
CDP is being used throughout the Certkiller network. What are two reasons why the Certkiller
network administrator would use CDP? (Choose two)
Which command has he run on the access point?
The network administrator of a company makes some changes in monitor mode of the access
point using a CLI session. This change affects the value of the channels that are monitored in the
monitor mode. Which command has he run on the access point?
Which physical layer function can a network administrator perform todetermine whether or not any device is sen
A company has a wireless network. In this network, collisions occur when more than one device
sends data at the same time. Which physical layer function can a network administrator perform to
determine whether or not any device is sending data to the channel?
Which address would you ping to perform this task?
The network administrator has asked you to check the status of the workstation’s IP stack by pinging the loopback address. Which address would you ping to perform this task?
What should be changed in the configuration to fix the problem?
Refer to the exhibit and the partial configuration on routers R1 and R2. Hot Standby Routing Protocol (HSRP) is configured on the network to provide network redundancy for the IP traffic. The network administrator noticed that R2 does not become active when the R1 serial0 interface goes down. What should be changed in the configuration to fix the problem? Select the best response.