For what two purposes does the Ethernet protocol use physical addresses?
For what two purposes does the Ethernet protocol use physical addresses? (Choose two.)
Which of the following packet destination addresses will R2 forward to R1, according to this summary?
The Ethernet networks connected to router R1 in the graphic have been summarized for router R2 as 192.1.144.0/20. Which of the following packet destination addresses will R2 forward to R1, according to this summary? (Choose two.)
Which series of commands will configure router R1 for LAN-to-LAN communication with router R2?
Which series of commands will configure router R1 for LAN-to-LAN communication with router R2? The enterprise network address is 192.1.1.0/24 and the routing protocol in use is RIPv2. (Choose three.)
which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:
Router Ethernet port – 1st usable address
Core – 2nd usable address
Core2 – 3rd usable address
For this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? (Choose three.)
What are two advantages of using Layer 2 Ethernet switches over hubs?
The Certkiller network administrator needs to determine what LAN devices to install on the
Certkiller network. What are two advantages of using Layer 2 Ethernet switches over hubs?
(Choose two)
Which controller CLI command assigns its management interface to the Cisco IOS Catalyst switch native vlan int
A controller is connected to a Cisco IOS Catalyst switch. The following is the switch port
configuration:
interface GigabitEthernet 1/0/10
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,20,30,50
switchport trunk native vlan 20
switchport mode trunk
Which controller CLI command assigns its management interface to the Cisco IOS Catalyst switch
native vlan interface?
In an Ethernet network, under what two scenarios can devices transmit?
In an Ethernet network, under what two scenarios can devices transmit? (Choose two.)
When troubleshooting a Frame Relay connection, what is the first step when performing a loopback test?
When troubleshooting a Frame Relay connection, what is the first step when performing a loopback test?
Which two Ethernet fiber-optic modes support distances of greater than 550 meters?
Which two Ethernet fiber-optic modes support distances of greater than 550 meters?
What needs to be done to ensure optimal data routing when using OSPF?
Your network has a mixture of Fast Ethernet and Gigabit Ethernet links. What needs to be done to ensure optimal data routing when using OSPF?
Select the best response.