Which statement describes a spanning-tree network that has converged?

Refer to the exhibit. C-router is to be used as a “router-on-a-stick” to route between the VLANs. All
the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs
have been configured with the appropriate default gateway. What can be said about this
configuration?

A static route to the 10.5.6.0/24 network is to be configured on the HFD router. The administrator
wants HFD to see this static route as the most reliable route . Which command should the
administrator use?

Assuming only one VLAN in the exhibit, which switch is acting as the root bridge?

Refer to the exhibit. What IP address should be assigned to Workstation A?

Refer to the diagram. Which three statements describe the router port configuration and the switch
port configuration as shown in the topology? (Choose three.)

Refer to the diagram. What is the largest configuration file that can be stored on this router?

It has become necessary to configure an existing serial interface to accept a second Frame Relay
virtual circuit. Which of the following procedures are required to accomplish this task? (Choose
three.)

LAB
The task is to create and apply an access-list with no more than three statements that will allow ONLY host C web access to the Finance Web Server. No other hosts will have web access to the Finance Web Server. All other traffic is permitted.

Given the partial outputs displayed in the graphic, which switch device would be the spanning tree
root bridge for a network of only these four devices?