Refer to the exhibit.
On all routers in the network, EIGRP has been configured for load balancing across the
three links. However, traffic destined for Network B from R1 is only load balanced over paths
R1-R2-R5 and R1-R3-R5. What is the cause of the problem?

Which are three features of EIGRP? (Choose three)

RouterA (DR) failed, and after 10 minutes it came back. Which two statements are true?
(Choose two)

Which of the below mentioned conditions form a neighbor relation in EIGRP? (Choose
Three)

The exhibit shows R1 topology table to reach 192.168.1.0/24 network.
Which route(s) will be installed in routing table of R1 to reach network 192.168.1.0/24 after
configuring R1 with the following command?
Router(config-router)# variance 2

Refer to the following.
Router # sh ip route eigrp
13.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
D 13.0.0.0/8 is a summary, 00:00:32, Null0
What happens to packets that are forwarded from the 13.0.0.0/8 network to the Null0
interface?

In which state do DR and BDR establish adjacency with each OSPF router in the network?

A stub area is typically created using what kind of topology?

A network administrator is troubleshooting an EIGRP connection between RouterA, IP
address 10.1.2.1, and RouterB, IP address 10.1.2.2.
Given the debug output on RouterA, which two statements are true?

Refer to the exhibit.
Network administrators have set up a hub and spoke topology with redundant connections
using EIGRP. However, they are concerned that a network outage between Router R1 and
Router R2 will cause traffic from the 10.1.1.x network to the 10.1.2.x network to traverse the
remote office links and overwhelm them. What command should be used to configure the
spoke routers as EIGRP stub routers that will not advertise connected networks, static
routes, or summary addresses?