What would be the effect of Issuing the command ip access-group 115 in on the s0/0/1 interface?
No host could connect to RouterC through s0/0/1.

CORRECT TEXT

A network associate is configuring a router for the weaver company to provide internet access.
The ISP has provided the company six public IP addresses of 198.18.184.105 198.18.184.110.
The company has 14 hosts that need to access the internet simultaneously. The hosts in the
company LAN have been assigned private space addresses in the range of 192.168.100.17 –
192.168.100.30.

CORRECT TEXT
Central Florida Widgets recently installed a new router in their office. Complete the network
installation by performing the initial router configurations and configuring R1PV2 routing using the
router command line interface (CLI) on the RC.
Configure the router per the following requirements:
Name of the router is R2
Enable. secret password is cisco
The password to access user EXEC mode using the console is cisco2
The password to allow telnet access to the router is cisco3

IPV4 addresses mast be configured as follows:
Ethernet network 209.165.201.0/27 – router has fourth assignable host address in subnet
Serial network is 192.0.2.176/28 – router has last assignable host address in the subnet.
Interfaces should be enabled.
Router protocol is RIPV2
Attention:
In practical examinations, please note the following, the actual information will prevail.
1. Name or the router is xxx
2. EnablE. secret password is xxx
3. Password In access user EXEC mode using the console is xxx
4. The password to allow telnet access to the router is xxx
5. IP information

CORRECT TEXT

CORRECT TEXT

CORRECT TEXT

The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does
this mean?

DRAG DROP
Drag the Frame Relay acronym on the left to match its definition on the right. (not all acronyms are used.)

Refer to the exhibit.

In the Frame Relay network, which IP addresses would be assigned to the interfaces with point-topoint PVCs?

Which command is used to enable CHAP authentication, with PAP as the fallback method, on a
serial interface?