Refer to the exhibit.

Is nonstop forwarding enabled or disabled, and which part of show command can be used to determine this?

You are connecting a Cisco WLC 4404 to your switch using all four ports and you have chosen not to use link aggregation protocol. You have been asked to provide a Guest SSID, a Voice SSID, and a Data SSID on separate broadcast domains. You are required to keep your management traffic separate from your user community. How many addresses must you request to complete this task?
Select the best response.

Refer to the exhibit.

The commands were exceeded on the cisco XR 12000 PE. Which statement is true?

You have set up a port channel with the following configuration and assigned the channel group appropriately to your physical interfaces. The Layer 3 configuration for your network is:
interface vlan1
ip address 10.1.1.1 255.255.255.0
!
interface vlan2
ip address 10.2.2.1 255.255.255.0
!
interface vlan3
ip address 10.3.3.1 255.255.255.0

!
interface Port-channel31
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
If the management interface has the IP address of 10.1.1.50, how do you answer the following initial controller configuration question?
Management Interface VLAN Identifier (0 = untagged):? Select the best response.

A Cisco MSE is not reachable from Cisco WCS. What is the most likely reason? Select the best response.

Refer to the exhibit.

You are troubleshooting a connectivity problem between the CE routers in your network running IS-IS. You login to one of the routers and execute a show log. What is the problem associated with these message?

What is the most likely reason to replace the Cisco LOC2710 with a Cisco MSE-3310 for tracking 1,500 clients?
Select the best response.

Refer to the exhibit.

The partial show run command out put is from PE router that provides MPLS VPN services to customer_1. What is the routing protocol and AS number used between the PE router and customer_1 CE router?

In a Cisco MSE-3350 deployment there are 10,000 tags and 7,000 clients to be tracked. The administrator is seeing the clients, but not the tags on the Cisco WCS. Which two issues are the most likely? (Choose two.)
Select 2 response(s).

What is the Cisco recommended way to upgrade Cisco MSE software? Select the best response.