What default failover priority do these new access points have using Cisco WLC version 5.2?
You have oversubscribed your redundant controller and two controllers on the same power source have failed. The first floor has just recently been deployed and you have not changed the default configuration of the access point priority. What default failover priority do these new access points have using Cisco WLC version 5.2?
Select the best response.
Select the best response.
You have oversubscribed your redundant controller and two controllers on the same power source have failed. The first floor has just recently been deployed and you have not changed the default configuration of the access point priority. What default failover priority do these new access points have using Cisco WLC version 5.2?
Select the best response.
Click and drag the elements on the left to the correct identifier on the right?
DRAG DROP
Refer to Exhibit. MPLS-TE is configured in the core and BFD is used for faster link failure detection. Currently the MPLS-TE tunnels are flapping. Identify the Symptom of the flapping, the root cause of the issue, and the resolution. Click and drag the elements on the left to the correct identifier on the right? It is possible that you will not use all the elements.
Click and drag the elements on the left to the correct identifier on the right?
DRAG DROP
Refer to Exhibit. MPLS-TE is configured in the core and BFD is used for faster link failure detection. Currently the MPLS-TE tunnels are flapping. Identify the Symptom of the flapping, the root cause of the issue, and the resolution. Click and drag the elements on the left to the correct identifier on the right?It is possible that you will not use all the elements.
Select the best response.
If you know someone is trying to physically access your mesh access points deployed on a pole top in an area, which is the most appropriate alarm to check on the Cisco WCS? Select the best response.
Select the best response.
When using third-party antennas that provide a gain greater than +6 dBi for Context-Aware software, the difference in gain between the third-party antenna and the Cisco equivalent should not exceed which gain level, assuming a fixed power level? Select the best response.
Drag the list of commands on the left to the proper command categories on the right?
Click and drag the elements on the left to the correct identifier on the right?
DRAG DROP
Refer to Exhibit. MPLS-TE is configured in the core and BFD is used for faster link failure detection. Currently the MPLS-TE tunnels are flapping. Identify the Symptom of the flapping, the root cause of the issue, and the resolution. Click and drag the elements on the left to the correct identifier on the right? It is possible that you will not use all the elements.