PrepAway - Latest Free Exam Questions & Answers

Category: 642-813

Implementing Cisco IP Switched Networks (SWITCH 642-813)

Which statement best describes first-hop redundancy protocol status, given the command output in the exhibit?

Which statement best describes first-hop redundancy protocol status, given the command output in the exhibit? *

Switch# show ip arp

Protocol AddressAge(min) Hardware Addr Type Interface
Internet 172.16.233.229 0000.0c59.f892 ARPA Vlan10
Internet 172.16.233.218 0000.0c63.1300 ARPA Vlan10
Internet 172.16.233.19 0000.0c07.ac0b ARPA Vlan10

What best describes the Cisco IOS IP SLA command and output in the exhibit?

Switch# show ip sla application
IP SLAs

Version: 2.2.0 Round Trip Time MIB, Infrastructure Engine-II Time of last change in whole IP SLAs: 22:17:39.117 UTC Fri Jun Estimated system max number of entries:15801

Estimated number of configurable operations: 15801 Number of Entries configured: 0
Number of active Entries: 0
Number of pending Entries: 0
Number of inactive Entries: 0

Supported Operation Types
Type of Operation to Perform: 802.1agEcho
Type of Operation to Perform: 802.1agJitter
Type of Operation to Perform: dhcp
Type of Operation to Perform: dns
Type of Operation to Perform: echo
Type of Operation to Perform: ftp
Type of Operation to Perform: http
Type of Operation to Perform: jitter
Type of Operation to Perform: pathEcho
Type of Operation to Perform: pathJitter
Type of Operation to Perform: tcpConnect
Type of Operation to Perform: udpEcho

IP SLAs low memory water mark: 21741224

Refer to the exhibit. What best describes the Cisco IOS IP SLA command and output in the exhibit?

which two of the following statements are true, based on the configuration shown in the exhibit?

Refer to the exhibit.

Consider the following scenario:
Packet A is a TCP packet from host 10.2.2.2., port 65000, going to host 10.1.1.1 on the SMTP port. Assuming that this ACL is properly applied on the switch, if this packet is fragmented, which two of the following statements are true, based on the configuration shown in the exhibit? (Choose two.)

What is the most likely cause of this status?

hostname Switch1
interface Vlan10
ip address 172.16.10.32 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 700
standby 1 preempt

hostname Switch2
interface Vlan10
ip address 172.16.10.33 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 750
standby 1 priority 110
standby 1 preempt

hostname Switch3
interface Vlan10
ip address 172.16.10.34 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 750
standby 1 priority 150
standby 1 preempt

Refer to the exhibit. Three switches are configured for HSRP. Switch1 remains in the HSRP listen state. What is the most likely cause of this status?


Page 5 of 33« First...34567...102030...Last »