Which of the following statements is true regarding VLAN 32?
You administer the network shown above. You issue the show interfaces trunk command on SwitchA and receive the following output:
SwitchA#show interfaces trunk
Port Mode Encapsulation Status Native vlan
Fa0/1 desirable 802.1q trunking 1
Port Vlans allowed on trunk
Fa0/1 1-4094
Port Vlans allowed and active in management domain
Fa0/1 1-9,31-37
Port Vlans in spanning tree forwarding state and not pruned
Fa0/1 1-9,31,33-37
Which of the following statements is true regarding VLAN 32? (Select the best answer.)
Exhibit
Which of the following should you do to configure the IP phone to override the priority of the data packets it
Refer to the exhibit.
Which of the following should you do to configure the IP phone to override the priority of the data packets it receives from the host? (Select the best answer.)
which three statements are true?
Refer to the exhibit. An administrator is verifying that a CEF FIB entry exists to destination network 192.168.150.0. Given the output generated by the show ip cef and show adjacency detail commands, which three statements are true? (Choose three.)
what is the cause of this problem?
The network operations center has received a call stating that users in VLAN 107 are unable to access resources through Router 1. From the information contained in the graphic, what is the cause of this problem?
Exhibit
What might explain what happened?
A switch that is to be added to the production network has been preconfigured (trunks, VLANs, VTP, and STP) and was tested in your lab. After installing the switch into the network, the entire network went down. What might explain what happened?
what can you determine regarding EIGRP routing being performed by the switch?
Refer to the exhibit. Based on the output of the show command, what can you determine regarding EIGRP routing being performed by the switch? *
what can you determine?
Refer to the exhibit. Based upon the output shown, what can you determine?
which two statements are correct regarding this Layer 3 security configuration example?
Refer to the exhibit. Based on the configuration shown, which two statements are correct regarding this Layer 3 security configuration example? (Choose two.)
what can you determine regarding Layer 3 routing functionality of the interface?
Refer to the exhibit. From the configuration sample shown of a Cisco Catalyst 3560 Series Switch,what can you determine regarding Layer 3 routing functionality of the interface?
what can be determined?
Refer to the exhibit. You have configured an interface to be an SVI for Layer 3 routing capabilities. Assuming that all VLANs have been correctly configured and based on the configuration example shown, what can be determined?