Which three of the following are valid in 6to4 Tunneling configuration?
To configure 6to4 on a dual-stack edge router. Which three of the following are valid in 6to4
Tunneling configuration? (Choose three)
which statement is true?
A network administrator is troubleshooting a redistribution of OSPF routes into EIGRP.
router eigrp 1
network 10.0.0.0
!
router ospf 1
network 172.10.0.0 0.0.255.255 area 0
redistribute eigrp 1
Given the exhibited commands, which statement is true?
Which three steps are most helpful in verifying proper route redistribution?
Which three steps are most helpful in verifying proper route redistribution? (Choose three.)
What is the function of the 25 parameter in the redistribute command?
A router is configured for redistribution to advertise EIGRP routes into OSPF on a boundary router.
Given the configuration:
router ospf 1
redistribute eigrp 1 metric 25 subnets
What is the function of the 25 parameter in the redistribute command?
Which action will correct this problem?
Refer to the exhibit.
R1 and R2 belong to the RIP routing domain that includes the networks 10.20.0.0/16 and
10.21.0.0/16. R3 and R4 are performing two-way route redistribution between OSPF and RIP. A
network administrator has discovered that R2 is receiving OSPF routes for the networks
10.20.0.0/16 and 10.21.0.0/16 and a routing loop has occurred.
Which action will correct this problem?
which path or paths would be chosen to route traffic to network X?
Observe the exhibit.
If the command variance 3 were added to RTE, which path or paths would be chosen to route
traffic to network X?
Which command should be added to RTB under router bgp 100 to allow only the external OSPF routes to be redistr
Which command should be added to RTB under router bgp 100 to allow only the external OSPF
routes to be redistributed to RTC?
What path will Router E take to reach Router A?
Router E is configured with the EIGRP variance 2 command.
What path will Router E take to reach Router A?
What must the administrator do to accomplish this?
A network administrator recently redistributed RIP routes into an OSPF domain. However, the
administrator wants to configure the network so that instead of 32 external type-5 LSAs flooding
into the OSPF network, there is only one.
What must the administrator do to accomplish this?
What should be configured on the routers in area 1 to ensure that all default summary routes…
Refer to the exhibit.
Routers R2, R3, R4, and R5 have OSPF enabled. What should be configured on the routers in
area 1 to ensure that all default summary routes and redistributed EIGRP routes will be forwarded
from R6 to area 1, and only a default route for all other OSPF routes will be forwarded from R5 to
area 1.