Which are three features of EIGRP? (Choose three)

Refer to the exhibit.

ROUTE.com is planning to implement load balancing for traffic between hosts on the
172.16.10.0/24 and 172.16.20./24 networks. You have been asked to review the implementation
plan for this project. Which statement about the plan is true?

Refer to exhibit.

RouterA (DR) failed, and after 10 minutes it came back. Which two statements are true? (Choose
two)

Which of the below mentioned conditions form a neighbor relation in EIGRP? (Choose Three)

Refer to exhibit.

The exhibit shows the R1 topology table to reach 192.168.1.0/24 network.
Which route(s) will be installed in routing table of R1 to reach network 192.168.1.0/24 after
configuring R1 with the following command?
Router(config-router)# variance 2

Refer to the following.
Router # sh ip route eigrp
13.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
D 13.0.0.0/8 is a summary, 00:00:32, Null0
What happens to packets that are forwarded from the 13.0.0.0/8 network to the Null0 interface?

In which state do DR and BDR establish adjacency with each OSPF router in the network?

A stub area is typically created using what kind of topology?

A network administrator is troubleshooting an EIGRP connection between RouterA, IP address
10.1.2.1, and RouterB, IP address 10.1.2.2.

Given the debug output on RouterA, which two statements are true?

Refer to the exhibit.

Network administrators have set up a hub and spoke topology with redundant connections using
EIGRP. However, they are concerned that a network outage between Router R1 and Router R2
will cause traffic from the 10.1.1.x network to the 10.1.2.x network to traverse the remote office
links and overwhelm them. What command should be used to configure the spoke routers as
EIGRP stub routers that will not advertise connected networks, static routes, or summary
addresses?