Your network consists of a large hub-and-spoke Frame Relay network with a CIR of 56 kb/s for
each spoke. Which statement about the selection of a dynamic protocol is true?

Refer to the exhibit.

Why are the EIGRP neighbors for this router not learning the routes redistributed from OSPF?

Refer to the exhibit.

Which three statements are true? (Choose three.)

Refer to the exhibit.

Looking at the topology diagram and the partial router configurations shown, which statement is
true?

You have implemented mutual route redistribution between OSPF and EIGRP on a border router.
When checking the routing table on one of the EIGRP routers within the EIGRP routing domain,
you are seeing some, but not all of the expected routes. What should you verify to troubleshoot
this problem?

You have implemented mutual route redistribution between OSPF and EIGRP on a border router.

When checking the routing table on one of the OSPF routers within the OSPF routing domain, you
are seeing some, but not all of the expected routes.
Which two things should you verify to troubleshoot this problem? (Choose two.)

Refer to the exhibit.

All EIGRP load balancing parameters are set to their defaults. You want to use all the routes in the
EIGRP topology for IP load balancing Which two EIGRP subcommands would you use to

accomplish this goal? (Choose two.)

Refer to the exhibit.

R1 accesses the Internet using E0/0. You have been asked to configure R1 so that a default route
is generated to its downstream neighbors (191.0.0.1 and 192.0.0.1). Which commands would
create this configuration?

Refer to the exhibit.

A partial routing configuration is shown. Complete the configuration so that only the default

network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the
configuration correctly?

Refer to the exhibit.

Which three commands should be used on router B1 to redistribute the EIGRP AS 10 routes into
RIP? (Choose three.)