Refer to the exhibit.

What additional commands should be used to configure OSPF area 5 as a Totally Stubby area?

Refer to the partial configurations in the exhibit.

What address is utilized for DR and BDR identification on Router1?

You are developing a verification plan for an upcoming OSPF implementation. Part of this plan is
to verify the status of type 3 LSAs within the network. Which routers should you verify first to
ensure that the configurations are correct for generating type 3 LSAs?

Refer to the exhibit.

Based on this command output, what can we conclude about R3?

Refer to the exhibit.

A new TAC engineer comes to you for advice. The engineer wants to
configure RIPv2- OSPF two-way redistribution while avoiding routing loops.
Which two additions to the router B1 configuration should the engineer make? (Choose two.)

what is the best order for choosing the Router-ID in ospf?

DRAG DROP
Click and drag the associated set of OSPF LEAs on the left to the corresponding area type on the right where this set of LEAs may be seen.

Refer to the exhibit.

ROUTE.com is planning to implement a secure OSPF network to support
traffic between clients on the 172.16.10.0/24 network and the file server on the 172.16.20./24
network. You have been asked to review the implementation and verification plans. Which
statement about the plan is true?

What is the sequence, from first to last, that OSPF will follow when choosing a router ID?

CORRECT TEXT
Route.com is a small IT corporation that is attempting to implement the network shown in the
exhibit. Currently the implementation is partially completed. OSPF has been configured on routes
Chicago and New York. The S0/0 interface on Chicago and the S0/1 interface on New York are in
area 0. The loopback0 on New York is in Area 1. However, they cannot ping from the serial
interface of the satellite router to the loopback interface of the New York router. You have been
asked to complete the implementation to allow this ping.
ROUTE.com’s corporate implementation guideline requires:
The OSPF process ID for all routers must be 24.
The routing protocol for all each interface must be enabled under the routing process.
The routing protocol must be enabled for each interface using the most specific wild card mask
possible.
The serial link between Seattle and Chicago must be in OSPF area 8.
OSPF area 8 must not receive any inter-area or external routers.

Network information
Seattle
S0/0 192.168.34.5/30 – link between Seattle and Chicago
Secret Password: Cisco
Chicago
S0/0 192.168.40.9/30 – link between Chicago and New York
S0/0 192.168.34.6/30 – link between Chicago and New York
Secret Password: Cisco