Refer to the exhibit. It is desired to set up a BGPneighbor relationship between routers R1
and R4. BGP packets between them could travel through R2 or R3. What is the simplest
configuration that will allow for failover? Select the best response.

When troubleshooting an EIGRP connectivity problem,you notice that two connected
EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was
successful. What is the next thing that should be checked? Select the best response.

Refer to the exhibit. Routers R1 and R2 have been configured to operate with OSPF.
Routers R1 and R3 have been configured to operate with RIP. After configuring the
redistribution between OSPF and RIP on R1, no OSPF routes are distributed into RIP. What
should be done to correct this problem?

When implementing OSPFv3, which statement describesthe configuration of OSPF areas?
Select the best response.

Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?
Select the best response.
Router1#
interface S1/1
ipv6 address 2001:410:FFFF:1::1/64
ipv6 ospf 100 area 0
!
interface S2/0
ipv6 address 3FFF:B00:FFFF:1::2/64
ipv6 ospf 100 area 1
!
ipv6 router ospf
router-id 10.1.1.3
————————————Router2#
interface S3/0
ipv6 address 3FFE:B00:FFFF:1::1/64
ipv6 ospf 100 area 1
ipv6 router ospf 100
router-id 10.1.1.4

By default, which statement is correct regarding the redistribution of routes from other
routing protocols into OSPF? Select the best response.

Which two routing protocols require a metric to be configured when redistributing routes
from other protocols? (Choose two.)

Refer to the partial configurations in the exhibit.What address is utilized for DR and BDR
identification on Router1?

A network administrator would like to configure an EIGRP router as a stub router that
advertises directly connected and summary routes only. What command must the
administrator issue to accomplish this?

Refer to the exhibit. EIGRP is enabled on all routers on the network. What additional
configuration is required for the routers connectedover the Frame Relay multipoint
interfaces to compensate for a low-speed NBMA connection?