Refer to the exhibit. Routers R1 and R2 have been configured to operate with OSPF.
Routers R1 and R3 have been configured to operate with RIP. After configuring the
redistribution between OSPF and RIP on R1, no OSPF routes are distributed into RIP. What
should be done to correct this problem?

A.
The redistribution command should be reentered withthe match route-type
parameter included.

B.
The redistribution command should be reentered withthe route-map map-tag
parameter included.

C.
The redistribution command should be reentered withthe metric metric-value
parameter included.

D.
Routes will first need to be distributed into another protocol, and then into RIP.

Explanation:
Notice that RIP metric is based on hop count only, and the maximum valid metric is 15.
Anything above 15 is considered infinite. By default, when no metric is assigned when
redistributing from EIGRP, OSPF, IS-IS, BGP into RIP, the default metric will be infinite.
Therefore we must define a metric that is understandable to the receiving protocol. Usually,
we should use a small value (like 1, 2, 3) so that after redistributing, that route can be
advertised through many routers (because the limit is 15).