What is the IPv6 address FF02::2 used for? Select the best response.

Which statement is true about IPv6? Select the bestresponse.

Refer to the exhibit. OSPF has been configured on all routers in the network and Area 1 has
been configured as a NSSA. Which statement is true about the NSSA Area 1? Select the
best response.

Which EIGRP packet statement is true? Select the best response.

Refer to the exhibit. On the basis of the output from the show ipv6 interface command, what
two statements must be true? (Choose two.)
RTA#show ipv6 ospf interfaces
<<output omitted>
!
Ethernet0/0 is up, line protocol is up
Link Local Address FE80:A8BB:CCFF:FE00:6E00, Interface ID 2
Area 0, Process ID 1, Instance ID 0, Router ID 10.10.10.1
Network Type BROADCAST, Cost: 10
MD5 Authenication SPI 500, secure socket state UP
(errors:0)
Transmit Delay is 1 sec, State DBR, Priority 1
Designated Router (ID) 11.11.11.1, local address
FE80:A8BB:CCFF:FE00:6F00
Backup Designated router (ID) 10.10.10.1, Local address
FE80:A8BB:CCFF:FE00:6E00
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello is due in 00:00:01
Index 1/1/1, flood queue length 0
Next 0x0(0)/0x0(0)/0x0(0)
Last flood scan length is 1, maximum is 1
Last flood scan time is 0 msec, maximum is 0 msec
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 11.11.11.1 (Designated Router)
Suppress hello from 0 neighbor(s)

Refer to the exhibit. What two statements are true?(Choose two.)
<<output omitted>
!
FastEthernet0/0 is up, line protocol is up
Link Local Address FE80::205:5FFF:FED3:5808, Interface ID 3
Area 1, Process ID 1, Instance ID 0, Router ID 172.16.3.3
Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DBR, Priority 1
Designated Router (ID) 172.16.6.6, local address
FE80::205:5FFF:FED3:6408
Backup Designated router (ID) 172.16.3.3, Local address
FE80::205:5FFF:FED3:5808
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello is due in 00:00:05
Index 1/1/1, flood queue length 0
Next 0x0(0)/0x0(0)/0x0(0)
Last flood scan length is 12, maximum is 12
Last flood scan time is 0 msec, maximum is 0 msec
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 172.16.6.6 (Designated Router)
Suppress hello from 0 neighbor(s)

Refer to the exhibit. EIGRP had converged in AS 1 when the link between router R1 and R2
went down. The console on router R2 generated the following messages:
*Mar 20 12:12:06: %DUAL-5-NBRCHANGE: IP-EIGRP 1: Neighbor 10.1.4.3
(Serial0) is down: stuck in active
*Mar 20 12:15:23: %DUAL-3-SIA: Route 10.1.1.0/24 stuck-in-active
state in IP-EIGRP 1. Cleaning up
The network administrator issued the show ip eigrp topology active command on R2 to
check the status of the EIGRP network. Which statement best describes the reason for the
error messages? Select the best response.

Refer to the exhibit. EIGRP has been configured on routers R1 and R2. However, R1 does
not show R2 as a neighbor and does not accept routing updates from R2. What could be
the cause of the problem? Select the best response.

Refer to the exhibit. Autonomous systems 200 and 300 have EBGP sessions established
with their directly connected routers in autonomoussystem 100. IGP has been configured
on all routers in autonomous system 100 and they successfully exchange routing updates.
Traffic originated in autonomous system 200 cannot reach the destination autonomous
system 300. What configuration should be done on the routers in autonomous system 100
in order for the traffic coming from autonomous system 200 to be forwarded to autonomous
system 300? Select the best response.

A router is running BGP and receives more than one route for a particular prefix.Assume all
the routes for this prefix have the same attributes. Which three path features would be
reasons be for the router to ignore some of the routes and not consider them as candidates
for the best path? (Choose three.)