Which ports will be STP designated ports if all the links are operating at the same bandwidth?
Refer to the topology shown in the exhibit:
Which ports will be STP designated ports if all the links are operating at the same bandwidth? (Choose three.)
Which two of these changes are necessary for SwitchA to meet the requirements?
Refer to the exhibit:
A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands. Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two.)
Which three of these show the correct RSTP port roles for the indicated switches and interfaces?
Refer to the exhibit:
Each of these four switches has been configured with a hostname, as well as being configured to run RSTP. No other configuration changes have been made. Which three of these show the correct RSTP port roles for the indicated switches and interfaces? (Choose three.)
Which statement is true?
Refer to the exhibit:
Which statement is true?
Which two statements describe the OSPF relationships between the routers?
Refer to the exhibit:
Which two statements describe the OSPF relationships between the routers? (Choose two.)
Which two of these statements correctly identify results of executing the command?
Refer to the exhibit. This command is executed on 2960Switch:
2960Switch(config)# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1
Which two of these statements correctly identify results of executing the command? (Choose two.)
Why are two OSPF designated routers designated routers identified on Core-Router?
Refer to the exhibit:
Why are two OSPF designated routers designated routers identified on Core-Router?
Why was RouterA not elected as the designated router?
Refer to the exhibit:
Why was RouterA not elected as the designated router?
How will the default route configured on R1 affect the operation of R2?
Part of the OSPF network is shown below:
Configuration exhibit:
You work as a network technician, study the exhibits carefully. Assume that all router interfaces are operational and correctly configured. In addition, assume that OSPF has been correctly configured on router R2. How will the default route configured on R1 affect the operation of R2?
which route or routes should appear in the routing table?
Based on the topology table that is shown in the exhibit and assuming that variance is not configured for EIGRP, which route or routes should appear in the routing table?