What type of wireless topology has been created?
You and a co-worker have established wireless communication directly between your wireless laptops. What type of wireless topology has been created?
which paramenter must be configured on the access point in order to allow a wireless client to operate on it?
You have finished physically installing an access point on the ceiling at your office. At a minimum, which paramenter must be configured on the access point in order to allow a wireless client to operate on it?
Which two features did WPAv1 add to address the inherent weaknesses found in WEP?
Which two features did WPAv1 add to address the inherent weaknesses found in WEP? (Choose two.)
What is a possible reason for this?
A wireless client cannot connect to an 802.11b/g BSS with a b/g wireless card. The client section of the access point does not list any active WLAN clients. What is a possible reason for this?
What speeds must be disabled in a mixed 802.11b/g WLAN to allow only 802.11g clients to connect?
What speeds must be disabled in a mixed 802.11b/g WLAN to allow only 802.11g clients to connect?
What are three likely causes of this problem?
A single 802.11g access point has been configured and installed in the center of a square office. A few wireless users are experiencing slow performance and drops while most users are operating at peak efficiency. What are three likely causes of this problem? (Choose three.)
What WAN service would meet this need?
A mid-sized company with five branch offices across Canada wants to create a WAN that will provide the most cost effective fully meshed environment with at least 512 kbps throughput. What WAN service would meet this need?
What are possible causes for this interface status?
The show interfaces serial 0/0 command resulted in the output shown in the graphic. What are possible causes for this interface status? (Choose three.)
What will fix this problem?
After the router interfaces shown in the diagram have been configured, it is discovered that hosts in the Branch LAN cannot access the Internet. Further testing reveals additional connectivity issues. What will fix this problem?
Which of the following statements is true concerning this command?
The command frame-relay map ip 10.121.16.8 102 broadcast was entered on the router. Which of the following statements is true concerning this command?