which two devices could be installed at the customer site to provide a connection through the local loop to th
Refer to the exhibit:
The network administrator must complete the connection between the RTA of the XYZ Company and the service provider. To accomplish this task, which two devices could be installed at the customer site to provide a connection through the local loop to the central office of the provider? (Choose two.)
what is the operational status of the interfaces of R2 as indicated by the command output shown?
Refer to the exhibit:
Assuming that the entire network topology is shown, what is the operational status of the interfaces of R2 as indicated by the command output shown?
what would be a logical first step to take to resolve this problem?
Refer to the exhibit:
The corporate office and branch location have been attached through two non-Cisco routers over a highly reliable WAN connection for over a year. A new Cisco router has been installed to replace the hardware at the branch location. Since the installation, IP communication cannot be verified across the link. Given the output on Branch1Router, what would be a logical first step to take to resolve this problem?
what is the most likely cause of the problem?
Exhibit:
Router 1# show running-config
<some output text omitted>
interface serial0/0
bandwidth 64 ip address 172.16.100.2 255.255.0.0
encapsulation frame-relay
frame-relay map ip 172.16.100.1 100 broadcast
As a technician, you found the router1 is unable to reach the second router. Both routers are running IOS version 12.0. Based on this information, what is the most likely cause of the problem?
which ip address would be assigned to the interfaces with point-to-point PVCs?
Refer to the exhibit:
In the Frame Relay network, which ip address would be assigned to the interfaces with point-to-point PVCs?
Which statement describes DLCI 17?
Refer to the exhibit:
Which statement describes DLCI 17?
What is the problem?
Refer to the exhibit:
A router interface is being configured for Frame Relay. However, as the exhibit shows, the router will not accept the command to configure the LMI type. What is the problem?
What is the cause of the problem?
Refer to the exhibit:
The Bigtime router is unable to authenticate to the Littletime router. What is the cause of the problem?
Which WAN protocol is being used?
Refer to the exhibit:
Which WAN protocol is being used?
What is the correct subnet mask for this network?
The router address 192.168.1.250 is the default gateway for both web server2 and host 1. What is the correct subnet mask for this network?
lab3_2-jpg (exhibit):
sample (exhibit):