Which command shows system hardware and software version information?
Which command shows system hardware and software version information?
What will happen in this scenario?
Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13. An 802. 1Q trunk is configured between the two switches. On CAT1, VLAN 10 is chosen as native, but on CAT2 the native VLAN is not specified.
What will happen in this scenario?
Which option is the valid IP address of this host?
The network default gateway applying to a host by DHCP is 192.168.5.33/28. Which option is the valid IP address of this host?
Which address would you ping to perform this task?
The network administrator has asked you to check the status of the workstation’s IP stack by pinging the loopback address. Which address would you ping to perform this task?
What two things can be done to allow communications between the hosts?
Workstation A has been assigned an IP address of 192.0.2.24/28. Workstation B has been assigned an IP address of 192.0.2.100/28. The two workstations are connected with a straight-through cable. Attempts to ping between the hosts are unsuccessful. What two things can be done to allow communications between the hosts? (Choose two.)
What is preventing the router from pinging remote devices?
Your ISP has given you the address 223.5.14.6/29 to assign to your router’s interface. They have also given you the default gateway address of 223.5.14.7. After you have configured the address, the router is unable to ping any remote devices. What is preventing the router from pinging remote devices?
Which command is used to copy the configuration from RAM into NVRAM?
Which command is used to copy the configuration from RAM into NVRAM?
Which command is used to load a configuration from a TFTP server and merge the configuration into RAM?
Which command is used to load a configuration from a TFTP server and merge the configuration into RAM?
If IP routing is enabled, which two commands set the gateway of last resort to the default gateway?
If IP routing is enabled, which two commands set the gateway of last resort to the default gateway? (Choose two.)
Which command would you configure globally on a Cisco router that would allow you to view directly connected C
Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?