What must be done to ensure that this new switch becomes the root bridge on the network?
The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch. What must be done to ensure that this new switch becomes the root bridge on the network?
Which protocols were used during the test?
A network administrator issues the ping 192.168.2.5 command and successfully tests connectivity to a host that has been newly connected to the network. Which protocols were used during the test? (Choose two.)
what is wrong with the IP configuration information shown?
Refer to the graphic. Host 1 cannot receive packets from Host 2. Assuming that RIP v1 is the routing protocol in use, what is wrong with the IP configuration information shown? (Choose two.)
What are three valid reasons to assign ports to VLANs on a switch?
What are three valid reasons to assign ports to VLANs on a switch? (Choose three.)
Which statements describe two of the benefits of VLAN Trunking Protocol?
Which statements describe two of the benefits of VLAN Trunking Protocol? (Choose two.)
What are two results of entering the Switch(config)# vtp mode client command on a Catalyst switch?
What are two results of entering the Switch(config)# vtp mode client command on a Catalyst switch? (Choose two.)
Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy?
The network security policy requires that only one host be permitted to attach dynamically to each switch interface. If that policy is violated, the interface should shut down. Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy? (Choose two.)
Which commands will accomplish this?
Refer to the graphic. A static route to the 10.5.6.0/24 network is to be configured on the HFD router. Which commands will accomplish this? (Choose two.)
What should be done prior to backing up an IOS image to a TFTP server?
What should be done prior to backing up an IOS image to a TFTP server? (Choose three.)
What are the possible trunking modes for a switch port?
What are the possible trunking modes for a switch port? (Choose three.)