Choose the Gateway to the proper locations
Choose the Gateway to the proper locations.
exhibit
Please match the phrase to the correctly completes the statement for each task…
Please match the phrase to the correctly completes the statement for each task.
(1)to be on the same subnet as the router
(2)with a static IP address or IP address unnumbered (3)to be the same as the service engine
(I)Configure the service engine interface
(II)Configure the service-module IP address
(III)Configure the Cisco Unity Express IP default gateway
Place the steps for inbound dial-peer matching in the correct order.
Place the steps for inbound dial-peer matching in the correct order. (1)If no matches are found, the system uses the default dial peer. (2)Look for the destination-pattern command in a dial peer that matches the calling number or ANI string of the incoming call leg.
(3)Look for the POTS dial peer port configuration that matches the voice port associated with the incoming call(POTS dial peers only)
(4)Look for the incoming called-number command in the dial peer that matches the called number or DNIS string in the inbound call leg.
(5)Look for the answer-address command in a dial peer that matches the calling number or ANI string of the inbound call leg.
(I)Step1
(II)Step2
(III)Step3
(IV)Step4
(V)Step5
what redundancy feature should be configured on remote site routers to provide basic IP telephony services in
In a Cisco UCM multisite WAN with centralized call-processing deployment model, what redundancy feature should be configured on remote site routers to provide basic IP telephony services in the event of a WAN outage?
When a Cisco switch supply PoE to an IP phone?
Power over Ethernet (PoE) is the ability for the LAN switching infrastructure to provide power over a copper Ethernet cable to an endpoint (Powered Device). This capability, once referred to as “inline power”, was originally developed and first delivered by Cisco in 2000 to support the emerging IP Telephony deployments. IP Telephones, like desktop PBX phones, need power for their operation and Power over Ethernet enables scalable and manageable power delivery and simplifies deployments of IP Telephony. As Wireless networking emerged, Power over Ethernet was also used to power these devices to allow for deployments in locations where local power access did not exist. While IP telephones and wireless access points are the most intuitive uses for PoE, the advent of 802.3af standardization of PoE opens the door to a new generation of networked-attached devices such as video cameras, point-of-sale devices, security access control (card scanners), building automation and industrial automation just to name a few. When a Cisco switch supply PoE to an IP phone?
What protocol does a Cisco IP phone use to indicate to the switch how much power is needed?
What protocol does a Cisco IP phone use to indicate to the switch how much power is needed?
Which protocol is used to inform the IP phone of its voice VLAN ID?
Which protocol is used to inform the IP phone of its voice VLAN ID?
What device is responsible for converting analog voice packets from traditional voice formats to IP packets?
What device is responsible for converting analog voice packets from traditional voice formats to IP packets?
What protocol is used to monitor and provide control information about the quality of an RTP session?
What protocol is used to monitor and provide control information about the quality of an RTP session?
What protocol does a Cisco IP phone use to indicate to the switch how much power is needed?
What protocol does a Cisco IP phone use to indicate to the switch how much power is needed?