Which two tabs that are most likely going to resolve this problem?
Exhibit
exhibit
You are also required to configure a second directory number 5010 as a shared directory number on line 2 of ea
3.130.254. IP addresses in the range 10.3.130.1 to 10.3.130.9 should be excluded. The IP phones are connected to an EtherSwitch module, interface GigabitEthernet1/0 on a Cisco 2811 router as per the topology diagram. The voice VLAN ID is 130 and default router for the IP phones is 10.3.130.1.
The EtherSwitch module has been preconfigured and is not configurable. You are also required to configure a second directory number 5010 as a shared directory number on line 2 of each IP phone.
Topology:
exhibit
Please match the CAS component to the office that it will apply.
Please match the CAS component to the office that it will apply.
(1)CAS E1 (2)CAS T1 (3)1.544 mb/s (4)2.048 mb/s
(5)RBS in-band (6)24 voice channels (7)30 voice channels (8)out-of-band signaling in time slot (I)London, United Kingdom (II)Chicago, United States
Configure Hunt Group so that all incoming PSTN calls always…
Configure Hunt Group so that all incoming PSTN calls always go to extension 5001. If extension 5001 is not available, route the call to extension 5002. If both extensions are busy or unavailable then send the call to Voicemail. About this question, we do not have proper answer, if you have then please contact us.
Which ephone-dn type does the picture represent?
Which ephone-dn type does the picture represent?
exhibit
What are two possible problems with this configuration?
10.29.33
HHTrenton(config-telephony)#exit
HHTrenton(config)#telephony-service
HHTrenton(config-telephony)#moh.rockin.au
HHTrenton(config-telephony)#multicast moh 224.10.16.4 port 2001 HHTrenton(config-telephony)#exit
Please match the description to the signaling type it corresponds to.
Please match the description to the signaling type it corresponds to. (1)events that occur on the trunk, including seizure, wink, and answer (2)tones such as ringing or busy and announcements such as “no longer in service” (3)digits dialed or called party number that can be sstem-specific or variant-specific (I)Address Signaling
(II)Supervisory Signaling
(III)Informational Signaling
Which two types of dial peers are needed to complete this call end-to-end?
Which two types of dial peers are needed to complete this call end-to-end?
exhibit
Which two commands should you use?
10.1.1. Which two commands should you use?
exhibit
Which ephone-dn type does the exhibit represent?
Which ephone-dn type does the exhibit represent?