Your company needs to connect a single analog telephone to UCM and has no plans to support the addition of
future analog voice or fax devices.
Which of the following are you most likely to deploy? (Select the best answer.)

Which of the following UCM services enables the use of Cisco Unified Personal Communicator in softphonemode when integrating a CUPS server with UCM? (Select the best answer.)

You issue the showrunning config command on a CME router and receive the following partial output:

A caller dials 3021234.
Which of the following dial peers will the router use? (Select the best answer.)

You issue the no ip source-address 172.16.0.1 command in telephony service configuration mode on a CME
router.
Which of the following is true? (Select the best answer.)

You are troubleshooting a PRI connection to the PSTN.
Which of the following state messages most likely indicates a Layer 2 problem? (Select the best answer.)

You want to test a new dial plan before you deploy the plan in a UCM environment.
Which of the following tools should you use? (Select the best answer.)

All of your department’s IP phones are connected to a switch that does not support PoE. The IP phones have
all been manually configured with IP addressing information. Another administrator power cycles the switch
without warning. No calls are in progress.
Which of the following is most likely to occur? (Select the best answer.)

Which of the following statements best describes DiffServ? (Select the best answer.)

You issue the following commands on a Cisco voice router:
voice translation-rule 1
rule 1 /^615/ //
voice translation-profile VCE
translate called 1
dia-lpeer voice 101 pots
translation-profile incoming VCE
direct-inward-dial
port 1/0:21
Which of the following will occur when you issue the test voice translation-rule 1 6155550121 command from
privileged EXEC mode? (Select the best answer.)

Which of the following can administrators display by clicking Device Reports > Gatewayin the CAR GUI?
(Select the best answer.)