Which two options can be used to enable flex-attach when automatic assignment is used?
Which two options can be used to enable flex-attach when automatic assignment is used?
(Choose two.)
Select 2 response(s).
NPV edge switch accomplishes this request?
A junior SAN engineer is asked to prepare the configuration for the NPV edge switch. The NPV
edge switch will be connected to the NPV core switch via the fc 1/24 interface. The end device will
be connected to the fc 1/1 interface and should be placed in VSAN 10. Which configuration for the
NPV edge switch accomplishes this request?
Select the best response.
CLI-based software upgrade?
What is a benefit of using the Cisco Fabric Manager Software Install Wizard instead of using the
CLI-based software upgrade?
Select the best response.
which protocol provides in-band management?
When using the Cisco MDS 9000 Switches, which protocol provides in-band management?
Select the best response.
Which Cisco MDS 9000 Series Switch has non-field-replaceable fans?
Which Cisco MDS 9000 Series Switch has non-field-replaceable fans?
Select the best response
Which second-generation Fibre Channel module offers a full 4Gb/s line rate on all ports?
Which second-generation Fibre Channel module offers a full 4Gb/s line rate on all ports?
Select the best response.
topologies?
Which two Cisco MDS 9000 Series Switches are used in small- and medium-sized SAN
topologies?
(Choose two.)
Which three of these terms are valid Fibre Channel topologies?
Which three of these terms are valid Fibre Channel topologies? (Choose three.)
Which error was made at initial configuration?
After performing the initial switch configuration by running the setup utility, an administrator notices
that ports configured to connect to other Cisco MDS 9000 switches invariably come up as E_Ports
rather than TE_Ports. Which error was made at initial configuration?
how many bits in the IPv4 address are used to identify the network?
On a Class C IP network, how many bits in the IPv4 address are used to identify the network?