Which two steps are necessary to configure inter-VLAN routing between multilayer switches?
Which two steps are necessary to configure inter-VLAN routing between multilayer
switches? (Choose two.)
What VLAN number value is an assigned to the default VLAN?
You are assigning VLANs to the ports of switch R1. What VLAN number value is an
assigned to the default VLAN?
Which statement about the Port Aggregation Protocol is true?
Which statement about the Port Aggregation Protocol is true?
Which of the following are updated in R1 every time a VLAN is modified?
The VLANs in switch R1 are being modified. Which of the following are updated in R1 every
time a VLAN is modified? (Select all that apply)
Which port state is interface Fa0/2 of switch SW-B in for VLANs 1 and 175?
Which port state is interface Fa0/2 of switch SW-B in for VLANs 1 and 175?
You must accomplish the following tasks?
SIMULATION
Case 1
You must accomplish the following tasks?
You are required to accomplish the following tasks:
SIMULATION
LAB
Refer to the Exhibit.
The information of the question
You will configure FastEthernet ports 0/12 through 0/24 for users who belong to VLAN 20.
Also, all VLAN and VTP configurations are to be completed in global configuration mode as
VLAN database mode is being deprecated by Cisco. You are required to accomplish the
following tasks:
1. Ensure the switch does not participate in VTP but forwards VTP advertisements received
on trunk ports.
2. Ensure all non-trunking interfaces (Fa0/1 to Fa0/24) transition immediately to the
forwarding state of Spanning-Tree.
3. Ensure all FastEthernet interfaces are in a permanent non-trunking mode.
4. Place FastEthernet interfaces 0/12 through 0/24 in VLAN 20
You have been tasked with planning a VLAN solution that will connect a server in one building to serveral host
DRAG DROP
You have been tasked with planning a VLAN solution that will connect a server in one building to serveral hosts in another building. 
Drag the choices on the left to the boxes on the right that should be included when creating a VLAN-based impl
DRAG DROP
Drag the choices on the left to the boxes on the right that should be included when creating a VLAN-based implementation plan. Not all choices will be used.
Put the highest level at the top and the lowest level at the bottom.
DRAG DROP
Syslog information can generate messages up to and including the configured severity level.
Organize the level by dragging each name from the left to the right.
Put the highest level at the top and the lowest level at the bottom.