Which two steps are necessary to configure inter-VLAN routing between multilayer
switches? (Choose two.)

A.
Configure a dynamic routing protocol.

B.
Configure SVI interfaces with IP addresses and subnet masks.

C.
Configure access ports with network addresses.

D.
Configure switch ports with the autostate exclude command.

E.
Document the MAC addresses of the switch ports.

Explanation:
To be honest configuration of dynamic routing protocol is no necessary to enable inter VLAN
routing between multilayer switches. The static routing would be enough. But as question
requires choosing two answers you are constrained to choose answer A beside the obvious
answer B.
Reference:
http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008019e74e.shtml