Which two statements describe information that you can derive from the WCS v7.0 output from the Monitor Client
Refer to the exhibit.
Which two statements describe information that you can derive from the WCS v7.0 output from the
Monitor Client Detail? (Choose two.)
What criteria must be met for a point to be considered location ready?
An engineer notes that some areas of a floor fail when using the Location Readiness Tool in Cisco
WCS. What criteria must be met for a point to be considered location ready?
How many location points are needed to validate both 802.11b/g and 802.11a in the Cisco WCS Calibration?
How many location points are needed to validate both 802.11b/g and 802.11a in the Cisco WCS
Calibration?
How is unicast encryption implemented on the client?
A wireless client has finished 802.1X and EAP using WPA2 with a controller-based AP network
using a central AAA server. How is unicast encryption implemented on the client?
What are the benefits from enabling TSM for a VoWLAN using a WLC v7.0?
What are the benefits from enabling TSM for a VoWLAN using a WLC v7.0?
What two tools can an engineer use to verify RF data rates and coverage after installation?
What two tools can an engineer use to verify RF data rates and coverage after installation?
(Choose two.)
How is the MSE enabled to support wIPS service?
How is the MSE enabled to support wIPS service?
What may prevent some clients from connecting?
During RF verification, some 5 GHz clients are unable to connect to certain APs, while other 5
GHz clients can connect to all APs. What may prevent some clients from connecting?
What redundancy model does this describe?
An engineer has WLC redundancy included in WLAN design documentation, where the WLCs are
loaded to half the license capacity therefore allowing half the WLCs to fail without an AP going
offline at a given time. What redundancy model does this describe?
Which WCS tool will be especially helpful to ensure that all VoWLAN configurations are consistent across all c
Which WCS tool will be especially helpful to ensure that all VoWLAN configurations are consistent
across all controllers?