Which three CLI commands are required if the guest WLAN is on WLAN 2?
An engineer is configuring the guest WLAN to redirect to a created login page uploaded to the
controller. Which three CLI commands are required if the guest WLAN is on WLAN 2? (Choose
three.)
Which two statements describe a dual-mode phone, such as the Apple iPhone 4S with iOS 5.0, in relation to Cisc
Which two statements describe a dual-mode phone, such as the Apple iPhone 4S with iOS 5.0, in
relation to Cisco VoWLAN? (Choose two.)
which two locations can the accounts be stored?
A lobby ambassador is creating guest access accounts. At which two locations can the accounts
be stored? (Choose two.)
Which statement describes an IGMP leave message to a router when IGMP snooping is enabled?
IGMP snooping has been enabled on a Cisco WLC v7.0, along with any other configurations that
are required for wireless multicast. Which statement describes an IGMP leave message to a router
when IGMP snooping is enabled?
What device will authenticate the user when a sponsor creates a guest account on the Cisco NGS?
What device will authenticate the user when a sponsor creates a guest account on the Cisco
NGS?
Which two debug commands should be utilized?
An engineer is troubleshooting the authentication interaction between a WLAN controller and the
authentication server. Which two debug commands should be utilized? (Choose two.)
Which two attributes can be enabled for checking by the Voice Audit Tool in Cisco WCS v7.0?
Which two attributes can be enabled for checking by the Voice Audit Tool in Cisco WCS v7.0?
(Choose two.)
Where should the ACL be applied to accomplish this with the least configuration?
An engineer needs to block SSH traffic going to the WLC, which does not originate on the
management interface. Where should the ACL be applied to accomplish this with the least
configuration?
how many IPv4 multicast addresses?
A single Layer 2 multicast address can map to how many IPv4 multicast addresses?
Which mechanism detects if VoWLAN clients are experiencing poor signal-to-noise ratio values…?
Which mechanism detects if VoWLAN clients are experiencing poor signal-to-noise ratio values
and causes the power of APs to increase as needed in order to rectify signal-to-noise issues?