Which statement is true regarding ProfiSAFE?

Cisco Industrial Ethernet switches are capable of sending alarm messages to ProfiNET management stations using the ProfiNET-IO protocol.
Which four are alarms that can be configured for an interface? (Choose four)

It is common to use Resilient Ethernet Protocol (REP) on the manufacturing floor as a resiliency protocol, as opposed to the Enterprise where it is not generally deployed.

What are two reasons why REP is more suitable for the plant floor? (Choose two)

You are making changes to a Stratix 5700 using an Add On Profile (AOP) and a controller
which is on-line with RSLogix5000.
When do the changes you have made get published to the switch?

What are three Cisco best practices for running I/O control traffic in a wireless environment? (Choose three)

Refer to the exhibit.

The Robot Cell is in a bottling plant. This cell environment needs to consider high flex, EMI, and possible exposure to moisture.

Which physical media components need to be considered to prevent network degradation or interruptions?

If the Link Fault alarm is connected to the minor relay and the FCS Bit Error Rate alarm is connected to the major relay, which commands will create an alarm profile called GigE with the alarms correctly mapped to the minor and major relays?

Refer to the exhibit.

Which values are correct for AP 2 to allow for efficient roaming?

Which best describes the difference between 802.11n and 802.11ac?

Refer to exhibit.

The administrator has configured the following device IP settings, but did
not keep track of which ports the devices were connected to. The administrator is able to
ping each device but needs to update the network documentation to include the switch and
interface where each device is connected. The administrator does not want to walk to each
device and switch to track down the information.

Which steps below would you execute in sequence to document the switch and interface where each device is connected?

1. View the ARP table on L3SW1
2. View the ARP table on the administrator’s station
3. View the ARP table on L2SW4
4. PING all the devices
5. View the MAC address table on all switches
6. View the MAC address table on the administrator’s station