What percentage of an I/O connection would you set the RPI in order to ensure the application has the most current data?

A cookie cutter machine requires 2 standard controllers and a safety controller. All of these controllers and machine level I/O have been placed on VLAN 104.
Both standard controllers must monitor a photocell on this machine.
Which IP address is used to transfer this status information?

Refer to the exhibit.

An expansion project added an E-Tap and Device Level Ring to interface FastEthernet1/1
of L2SW1. The administrator has looked at the logs of L2SW1 and found that
FastEthernet1/1 was in an error-disabled state.Using command line access on L2SW1,
the administrator issued the following commands in configuration mode:

L2SW1(config)# interface FastEthernet 1/1
L2SW1(config-if)# shutdown
L2SW1(config-if)# no shutdown

The administrator checked the logs of L2SW1 and found the following:
Mar 30 02:23:17.588: %PM-4-ERR_DISABLE: bpduguard error detected on Fa1/1, putting
Fa1/1 in err-disable state

The administrator checked the software configuration of the switch port and found the following:
interface FastEthernet1/1
switchport access vlan 310
switchport mode access
speed 100
duplex full
no mdix auto
spanning-tree portfast
spanning-tree bpduguard enable

Why has the port gone error-disabled?

ProfiNET has been disabled on a Cisco Industrial Ethernet switch.
Which CLI command will correctly enable ProfiNET on the switch?

Which describes a best practice rule for controlling traffic between the corporate network and the controls network?

Profinet has been disabled on a Cisco Industrial Ethernet switch, which CLI commands correctly enable ProfiNET on VLAN 10?