If the link between Routers B and C was lost, what would be the relevant entries in the LFIB table for label,
Which of the following statements explains why it is normally best to have more than one controller-based acce
Which of the following statements explains why it is normally best to have more than one controller-based access point participate in the containment of one rogue access point?
should verify that the file name is which of the following?
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has become
corrupt. You must therefore reload the TFTP firmware. Before you press and hold the MODE button, you
should verify that the file name is which of the following?
What will Router Certkiller 3 and router Certkiller 4 add to their LIB regarding network X?
Network topology exhibit
Liberal label retention and unsolicited downstream distribution is being used in the frame-mode MPLS network shown in the exhibit. The best to network X as defined by the IGP for network is Certkiller 1- Certkiller 2- Certkiller 4- Certkiller 5. What will Router Certkiller 3 and router Certkiller 4 add to their LIB regarding network X?
Which command will enable DHCP debugging on a WLAN controller?
Which command will enable DHCP debugging on a WLAN controller?
must have heard the client within how many seconds?
In order for a controller-based access point to be allowed to participate in aggressive load balancing, it
must have heard the client within how many seconds?
perspective?
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client that is
anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run a debug
command on the 4402 controller.
Which message would best describe the establishment of the tunnel from the foreign controller’s
perspective?
In addition to implementing PSPF or peer-to-peer blocking on the wireless side, which of the following actions
You are charged with implementing a secure wireless installation which will provide Internet access to client devices but will not allow communications between wireless clients. In addition to implementing PSPF or peer-to-peer blocking on the wireless side, which of the following actions should you perform on the wired infrastructure?
accomplish this, which two IETF RADIUS attributes should you configure on the Cisco Secure ACS?
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. In order to
accomplish this, which two IETF RADIUS attributes should you configure on the Cisco Secure ACS?
(Choose two.)
What does this indicate?
On a Cisco Aironet 1240AG Series standalone access point, the radio LED is dark blue and blinking,
but the status LED and Ethernet LED are both off. What does this indicate?