Some of the AS-Paths listed will not be used.
DRAG DROP
Network X originates in AS 65103. Select the correct AS Path information for the Network X update and drag it into the appropriate box.
Some of the AS-Paths listed will not be used.
Which of the following is the correct partial router configuration to cause updates from CK1
Refer to the partial topology diagram shown.Service Provider 1 (SP1) assigned the customer an AS number of 65275. Service Provider 2 (SP2) assigned an AS number of 65745 to Domain . Domain decides to use AS 65275 internally.Which of the following is the correct partial router configuration to cause updates from CK1 to SP1 to report a source AS of 65275, while updates from CK2 to SP2 report the source AS of 65745 in addition to AS 65275?
Exhibit:
SIMULATION
SIMULATION
Network topology exhibit
Domain .com recently issued a contract to ISP (AS 65020) to provide a second Internet connection their Boston location. A new router, Domain 3, will need to be configured to connect to the Internet Service Providers. It is necessary to configure this router to exchange routes with both ISPs, and to filter the routing advertisements out to the ISPs. The basic configuration for the new router has been entered. It is only necessary to complete the BGP configuration steps outlined below.
On the Domain 3 router:
Configure BGP to exchange routes with ISP-A (AS 65010). Configure BGP to exchange routes with ISP-B (AS 65020). Only announce the two local Ethernet LAN prefixes (172.16.1.0/24 and 172.16.2.0/24) to the ISPs.
Configure the appropriate as-path access-list to permit only locally originated routes to be advertised in outbound routing updates to the ISPs. Use as-patch ACL number 10 containing only one statement. Start the simulation by clicking on the local host icon.
which BGP feature allows a BGP router
During the autonomous system number migration process, which BGP feature allows a BGP router to act as a router within one autonomous system to some BGP neighbors but also appear to be in another autonomous system to other neighbors?
Drag the correct description on the left to the EBGP, IBGP or IGP category on the right?
DRAG DROP
Drag the correct description on the left to the EBGP, IBGP or IGP category on the right?
Drag the description related to route reflector on the left to the term that it describes?
DRAG DROP
Drag the description related to route reflector on the left to the term that it describes?
What default failover priority do these new access points have using Cisco WLC version 5.2?
You have oversubscribed your redundant controller and two controllers on the same power source have failed. The first floor has just recently been deployed and you have not changed the default configuration of the access point priority. What default failover priority do these new access points have using Cisco WLC version 5.2?
Select the best response.
Drag the BGP MED function on the left to the command that enables it on the right.
DRAG DROP
Drag the BGP MED function on the left to the command that enables it on the right.
Not all apply.
Exhibit:
What is the default EAP timeout value in a Cisco WLC v7.0?
Authentication timeout values can sometimes require changing if they are too aggressive for wireless clients. What is the default EAP timeout value in a Cisco WLC v7.0?
Drag the correct description on the left to match the appropriate BGP feature on the right?
DRAG DROP
Drag the correct description on the left to match the appropriate BGP feature on the right?
